Headphone stand for a recording desk
Headphone stand generated for a recording desk starts at 186 × 128 × 350 mm and 720 g in Aluminium 6061-T6 — €104 including VAT, delivered in about 8 working days, or €54 if you can wait 38. The yoke radius is matched to the headband so that contact is spread over at least 60 mm of pad, and the stand is tall enough that the cups hang clear of the desk surface.
What a recording desk actually demands
Studio headphones are heavy, expensive, and left on the desk between takes. The failure mode is not dropping them; it is the slow crease that a narrow hook presses into the headband foam over a year.
The yoke radius is matched to the headband so that contact is spread over at least 60 mm of pad, and the stand is tall enough that the cups hang clear of the desk surface.
The starting point this page generated
Everything in the specification below was computed, not written. We passed “headphone stand wider yoke, taller” to the same generator the configurator uses, and this is what came back: a buildable headphone stand with every dimension inside the range the partner factory has qualified.
It is a starting point, not a product. Change any parameter in the configurator and the mass, the price, the tolerances and the manufacturability findings all recompute before you order.
Why this one can ship in days
Because most of it already exists. Turned base is a platform part — identical in every configuration, made in volume and held in stock. Only post and yoke are made for your order, by cut to length from stock, which starts the same day because it needs no tooling.
General dimensions hold ISO 2768-m, which at this size means ±0.5 mm; the fits that matter carry explicit ISO 286 callouts in the table above. The batch lane makes the same geometry by moulding or nesting it in a production run and sends it by sea: €54 in about 38 working days.